Overview:
This manual recalibration guide is only for the S1 Plus. For the original S1 refer to Installing the Necessary Firmware section of this guide.
Follow these steps to manually recalibrate your Infinity Flow S1 Plus.
⚠️ Note: This is only for the S1 Plus not the Original S1
Instructions:
Step 1: Update S1 Plus
In FlowQ, update device to v2.0.1 or later. Update Guide.
Step 2: Turn on S1+
1. With device powered off, press and hold the Bluetooth button.
2. Continue to hold BT button and power on the device. Hold until lights turn white (5-10 seconds).
Step 3: Calibrate
1. Press down on the front right lever, till light goes green, then release
2. Repeat for left side.
3. Release and wait till both lights go green, and then to red.
